Investigations by Make
Acura Investigations
9 investigations. 4 open. 5 closed.
Investigation Records
All wheel drive allegation
The Office of Defects Investigation (ODI) received a Petition dated January 9, 2026, requesting an investigation into the loss of the optional all-wheel drive capability in model year (MY) 2021-2023 Acura TLX and MY 2022-2023 Acura MDX vehicles. The Petition contends that the interfacing splines between the transmission and the rear wheel drive power take off unit are failing. Failure of these splines prevents the transfer of drive power to the rear axle, making the vehicle front wheel drive only. The Petition further alleges that this failure results in a reduction of vehicle directional control. The Petitioner cites 48 complaints received by ODI alleging the same failure. ODI will evaluate these complaints to determine if they are related to the failure cited in the Petition and will conduct a technical review under 49 CFR Part 552. This Defect Petition is being opened to evaluate whether to grant or deny the Petition. The Petition can be viewed at NHTSA.gov under NHTSA Number 11712885. The VOQ numbers referenced in the Petition are listed below. 11615217, 11619288, 11633510, 11634618, 11634979, 11636677, 11637484, 11638577, 11638902, 11640757, 11642028, 11642839, 11644661, 1
Loss of braking force
On October 23, 2025, the Office of Defects Investigation (ODI) opened Preliminary Evaluation PE25015 after receiving complaints concerning a loss of brake assist in 2019-2020 MY Acura ILX vehicles. These complainants alleged master cylinder failures resulting in soft pedal feel or the brake pedal intermittently going to the floor. These failures could result in extended braking distance increasing the risk of a crash. Honda found that residual plasticizer in the brake reservoir hose could contaminate the brake fluid. This contaminated brake fluid was then absorbed by the secondary cup seal, causing it to swell. Engine heat during operation could further expand the swollen seal, allowing brake fluid to pass. Brake fluid bypassing the master cylinder cup seals can reduce brake-pedal firmness and increase stopping distance. On April 08, 2026, Honda filed Recall 25V-859, recalling all 2016-2020 MY Acura ILX vehicles produced from October 9, 2014, to January 29, 2020. Under the recall, the dealer will replace the brake master cylinder with redesigned inner cup seals made of a different material, providing improved sealing capability. In view of Honda filing Recall 25V-859 addressing the
Engine failure
The Office of Defects Investigation (ODI) has received 414 reports of connecting rod bearing failures in the 3.5L V6 engine used in the following vehicles: Model Years (MY) 2018-2020 Acura TLX, MY2016-2020 Acura MDX, MY2016-2020 Honda Pilot, MY2018-2020 Honda Odyssey, and MY2017-2019 Honda Ridgeline. The subject engine failures were analyzed as part of a Recall Query (RQ24013). It was determined that these engine failures are outside the scope of Honda Recall 23V-751. Further, evidence gathered in conjunction with RQ24013 does not suggest this failure is caused by the same crankshaft manufacturing defect that is addressed by Honda in Recall 23V-751. Based on analysis of data from RQ24013, NHTSA has closed that investigation. The significant number of reports of engine failure in vehicles outside the scope of RQ24013 presents a potential safety risk that warrants further investigation. ODI is opening this Preliminary Evaluation (PE) to further evaluate the scope and severity of the potential problem and to fully assess the potential safety-related issues. To review the ODI reports cited in the Opening Resume ODI Report Identification Number document, go to NHTSA.gov.
No Restart After Auto Start/Stop Engages
On June 3, 2022, the Oï¬ce of Defects Investigation (ODI) opened Preliminary Evaluation PE22005 after the agency received VOQs and several ï¬eld reports concerning the Auto Idle Stop (AIS) feature on 2016-2019MY Honda Pilot vehicles. The complaints allege that the engine fails to restart on its own from a complete stop at a traï¬c light or road intersection with the AIS function engaged. The subject vehicles are equipped with a 3.5L engine with a 9-speed automatic transmission. On January 6, 2023, Honda released service bulletins 23-008 and 23-009. These service bulletins address the failure to restart issue in the 2016-2019MY Honda Pilot vehicles, as well as the 2015-2020 Acura TLX, 2016-2020 Acura MDX, 2019-2022 Honda Passport, and 2020-2023 Honda Ridgeline vehicles. The repair outlined in the service bulletins is a two-stage countermeasure to remedy the issue. The first stage is a Programmed Fuel Injection (âPGM-FIâ) software update. The second stage is only deployed if the software update fails to remedy the issue. The second stage, depending on the model and model year, consists of replacement of the starter assembly, starter relays, and a valve adjustment. Additionally
Engine failure
On November 8, 2024, the Office of Defects Investigation (ODI) opened Recall Query RQ24013 to assess the scope of Honda recall 23V-751 after receiving complaints that alleged connecting rod bearing failures in vehicles that were not within the scope of recall 23V-751. In November 2023, Honda recalled 248,999 various Model Year (MY)2016â2020 Honda and Acura vehicles equipped with the 3.5L V6 engine. Honda recalled these vehicles due to a crankshaft manufacturing defect that caused premature connecting rod bearing wear and engine seizure. While the out-of-scope failures involved in these complaints appear to have a very similar failure mechanism as the recalled engines, a thorough analysis of all available data from Honda has not indicated that the same manufacturing defect exists in the out-of-scope engines as the engines recalled by 23V-751. Based on this analysis ODI has determined that Honda has properly defined the scope of recall 23V-751. Consequently, ODI will close this RQ investigation. NHTSA will continue to investigate these complaints of engine failure as part of a new Preliminary Evaluation Investigation (PE25008). The Agency reserves the right to take additional act
Momentary Increased Steering Effort
On November 29, 2023, the Oï¬ce of Defects Investigation (ODI) opened this Engineering Analysis (EA23003) to assess allegations of momentary increase in steering eï¬ort in model years (MY) 2022-2023 Honda Civic, 2023MY Honda CR-V, and 2023MY Acura Integra vehicles (subject vehicles). The complaints received by ODI alleged that the subject vehicles experienced a momentary increase in required steering eï¬ort (described as âsticky steeringâ) occurring mostly at highway speeds after driving for an extended amount of time; these complaints could not be duplicated during dealer service techniciansâ quick test drives. The complaints had been received over the previous two years with most occurring with low vehicle mileage. The steering gear of these vehicles is aided by an electrical power assist unit. This power assist unit inputs force on the steering rack via a worm gear and worm wheel assembly. During PE23005, Honda stated this condition of momentary increase in steering eï¬ort occurs due to two factors within this power assist unit. First, during manufacturing, the steering worm wheel goes through annealing and component conditioning processes. These processes cause inte
Pedestrian alert sounds
NHTSA received a petition on or about July 18, 2022, requesting that Federal Motor Vehicle Safety Standard (FMVSS) 141 be applied to all electric and hybrid vehicles operating in the United States. The petition can be reviewed at NHTSA.gov under ODI Number 11486072. FMVSS 141 establishes performance requirements for pedestrian alert sounds for motor vehicles. The standard applies to hybrid and electric vehicles that have a gross vehicle weight rating of 4,536 KG or less or are defined as low-speed vehicles. The standard became fully applicable to all such vehicles manufactured on or after March 1, 2021.On January 27, 2023, NHTSA opened Defect Petition (DP) 22-005 to evaluate the subject matter described in the petition. On June 24, 2023 and as supplemented on June 25, 2023, the petitioner notified NHTSA he was withdrawing his petition. The petitioner indicated that, based on his review of data, there is no justification for asserting potential benefits that could be derived from actions sought by my petition. Based on the petitioner's withdrawal, DP22-005 is closed. Closure of this DP does not represent a determination by NHTSA regarding the subject matter of the petition.
Desiccated Air Bag Inflator Rupture
From 2000 through 2017, Takata produced millions of air bag inflators using two types of phase-stabilized ammonium nitrate ("PSAN") propellant -- propellant 2004 and propellant 2004L. After prolonged exposure to high temperature cycles and humidity, inflators using propellant 2004 can degrade, causing the propellant to burn too quickly when ignited. The rapid burning can cause the inflator to rupture during deployment, potentially causing serious or even fatal injury to vehicle occupants. See 2016 Blomquist Report at www.nhtsa.gov/sites/nhtsa.gov/files/documents/expert_report-hrblomquist.pdf.Consequently, all frontal inflators using propellant 2004 that do not contain a "desiccant" (a substance that traps and holds moisture) in US vehicles are under recall. These "non-desiccated" inflators either have been or are required to be replaced.In some cases, the remedy part for these recalled inflators was, or will be, an inflator using either propellant 2004 or 2004L that does contain a desiccant. None of these "desiccated" remedy parts (which were installed in older model year vehicles) are currently under recall for a degradation concern. Certain subsets of desiccated PSAN inflators us
Electrical overstress
The Office of Defects Investigation (ODI) opened this investigation to determine if the failure of airbags to deploy during severe crashes, in certain vehicles, was the result of a safety related defect. During the investigation a complex failure was studied that can result in non-deployment of subject vehicle air bags and other restraint system devices in severe crash events. The subject vehicles may be equipped with an airbag control unit (ACU) for the supplemental restraint system (SRS) Electronic Control Unit (ECU) manufactured by ZF-TRW.  The ECU receives signals from crash sensors mounted in the vehicle and deploys the vehicle air bags and seat belt pretensioners in accordance with manufacturer design specifications.  The ECU in the subject vehicles contains a model DS84 application-specific integrated circuit (ASIC) which controls the communication of the crash sensor signal, firing commands (i.e., when to deploy the airbag(s) and/or pretensioners), and fault information (e.g., diagnostic trouble codes). In September 2016, FCA announced recall 16V-668 for certain model year (MY) 2010 to 2014 Chrysler, Dodge and Jeep products manufactured with the subject ZF-TRW ACU.  In